The last few months, we have been building up our very own 3D printer farm, and we are happy to show you a glimpse of it. We have worked with Prusa printers originating from Prague for a long time and have decided to build our farm around their printers. It is a setup...

In December 2020 we built the first functional and finished Merlin400 version B02. BO2 is our internal numbering system for versions, and B02 is the first zero series of extractors we have planned. With a degree of humility, Peter Christensen sat down and used the...

  17th September 2020 Drizzle was subject to an onsite audit from the Danish Medicines Agency. Drizzles permit to grow, handle, extract and analyze cannabis was updated and approved to follow the already started path. The Danish Medicines Agency audited our...

As a part of Force Technology, Delta has worked with the reliability of new and existing products through several decades. They have in-house facilities for performing all relevant tests needed to help in planning and designing robust solutions.  During 2019 and 2020,...

Today we managed to fully automate the process we developed in mid-2018, by using the actual active components used in the final extractor product. We managed to perform an entire extraction from starting cannabis flower to a finished decarboxylated extract with only...

The use of 3D printed polymers for use as food contact material is still controversial. You can find many opinions on the internet, scattered across articles, forums etc. What is consistent through most of the information found is that there is a general lack of...